For Panel Table Saws, We Are Professional

                                                                                   450 table saw

                                                                                   Saw blade can be tilted, not only can cut right Angle can effectively cut 0-450 plate, used for solid wood furniture, soft bag and so on.

                                                                                   90 ° table saw

                                                                                    Can only be cut square, used in the manufacture of panel furniture cabinets, wardrobe, etc. Construction industry, etc.

          1 double layer thickened push table (the peers are basically single layer)

          2. All the connecting bases of the fuselage and the sliding table are planed and milled, so that there will be no error before and after the sliding table (more than 95% of the manufacturers save this process)

          3. All bearings have been replaced by SKF bearings from Japan to solve the problem of saw shaft heating and noise (the cost has increased by more than 1000 in order to solve the problem of noise and extend the service life of the machine)

          4. The cast iron worktable is equipped with protective saw blade to ensure that the saw blade will not be damaged due to touching the cast iron worktable in the process of lifting

          5. The machine is equipped with dust cover and pusher (as above)

          6. Add German technology high-end saw blade (saw blade has many repeat customers, not ordinary trial saw blade)

          7. The profiling column is upgraded to thicken chrome plated and rust free (rust free means smooth sliding and damp free)

          8. The ruler baffle is upgraded to aluminum alloy baffle, so that the thin plate will not pass under the baffle, and the baffle will slide smoothly (the low end is made of polyester synthetic material, and there is error in molding)

          9. The positioning groove of the push table is added to avoid the displacement of the push table during transportation (small details, solving big problems)

         10.Before leaving the factory, all the machines can be debugged to the accuracy of less than 20 wires, so that they can pass the quality inspection department, and try their best to make it easy to install and use after customers receive it.

               If you need more information, you can pay attention to our shop, wish you have a nice day！