Working principle and common problem answers of edge banding machine

1、 Working principle of edge banding machine

Edge banding machine is a type of machine used for processing wooden board edges, which can fix the edge banding strip on the surface of the cut board. The working principle of the edge banding machine is to place the edge banding strip on the edge of the board, then use a heater to heat and soften the edge banding strip, and finally use an edge press to press the edge banding strip firmly to the surface of the board.

2、 Instructions for using edge banding machine

1. Preparation work:

Prepare the boards and edge banding strips that need to be processed, and adjust the working parameters of the edge banding machine, such as heating temperature, edge pressure, etc.

2. Edge banding feeding:

Place the edge banding strip on the feeding rack, start the edge banding machine, and let the feeding device deliver the edge banding strip to the heater.

3. Heating edge banding:

The heater heats the edge banding to soften it and bond it to the surface of the board.

4. Edge pressing:

The edge press presses the softened edge banding to ensure complete adhesion with the surface of the board.

5. Edge cutting:

Use a border cutter to cut off excess edge banding.

3、 Common problems and solutions of edge banding machine

1. The edge banding is not firmly bonded:

It may be due to insufficient heating or heating time, and the heating temperature or heating time can be appropriately increased.

2. The edge banding is prone to loosening when exposed to water:

It may be due to incomplete or weak adhesion between the edge banding and the surface of the board. It is recommended to increase the pressure of the edge press or extend the heating time appropriately.

3. Whitening phenomenon of edge banding:

It may be due to heating transition or excessive heating time, and the heating time or temperature can be appropriately reduced.

4. Uneven cutting of edge banding:

It may be due to wear or improper adjustment of the cutting blade, which can be replaced or adjusted.

4、 The name of the first tool used to cut off the edge banding strip in the edge banding machine

According to the standard operating procedure, the first tool used by the edge banding machine to cut off the edge banding strip is called a cutting blade.

In short, edge banding machine is an important tool for processing sheet metal edges. Understanding its working principle and common problem-solving methods can better improve the operation process and enhance processing efficiency.