What Should I Do If The Head Of The Foam Engraving Machine Does Not Rotate?

Have you ever experienced the situation where the head of the foam engraving machine can't rotate? In fact, this problem is not complicated, and it can be effectively solved by accurately finding the root cause and analyzing it. Therefore, let’s follow my steps to learn and understand what to do when the head of the foam engraving machine can’t rotate!

First of all, the most likely problem is the air cylinder, spindle or frequency converter of the foam engraving machine. Most of the problems between them are related to a certain degree. After understanding this point, you can continue to analyze further.

If the frequency converter and the main shaft of the foam engraving machine are normal after inspection, it should be that there is a problem with the air cylinder of the foam engraving machine. If there is a problem with the movement of the second cylinder of the foam engraving machine, it may be that the solenoid valve cannot receive the signal, or the suction of the contactor is malfunctioning. It may also be due to the power supply problem of the main shaft or the pressure problem of the trachea.

Secondly, there may be a failure in the power or external structure of the foam engraving machine. At this time, it is necessary to check its voltage stability, motor cables and other components.

Finally, after finding the root cause of the non-rotating head of the foam engraving machine, you can "prescribe the right medicine". For example, tighten the connection of the switch or circuit, set the relevant parameters of the spindle rotation or stop, reconnect the spindle motor and the inverter of the engraving machine, etc. However, if it is caused by a major failure inside the device, it must be It is necessary to carry out the replacement or maintenance of related parts in time to prevent unnecessary safety hazards and restore the normal operation of the foam engraving machine as soon as possible.