Small Woodworking Machine For Plate Planer

The role of flat wound bed in production
1. The planer is used to process the rough rough rough surface of the workpiece into a smooth and flat plane, which is used as the reference plane for subsequent processing.
2. The flat cutting machine can also use the guide ruler to process the adjacent surface of the datum into an angle plane with the base surface
3. At present, most planers are manually fed, and only mechanical feeding is used in batch production

Save labor costs

Power supply protection

Humanized design workbench

Safety protection device

Planer is divided into single-sided and double-sided press planer

Artificial board peeling and polishing machine

Single-sided planing

Factory wholesale

Table planer

Common defects and removal methods of the press
Defect type: 1. The thickness of the workpiece is inconsistent in the width direction
Cause: the extension of the blade in the length direction of the cutter shaft is inconsistent, and the edge is not parallel to the workbench; The workbench is loose and skewed
Troubleshooting: calibrate and adjust the workbench, eliminate the gap and adjust the workbench, and clean the grinding workbench.

 

Defect type: work-piece tail gnawing (tearing)

Cause: the supporting roller behind the workbench is adjusted too high

Troubleshooting: readjust the roller

Defect type The surface of the workpiece is uneven and wavy
Causes: The drum on the workbench protrudes too much, the chip breaker and compactor are adjusted too low, and the radial clearance of the cutter shaft bearing is too large.
Troubleshooting: adjust the roller, adjust the position of chip breaker and compactor, and replace the bearing